NEC ASPILA EX - ANI;DNIS Service Options

Program 34 : Tie Line Setup
34-09 : ANI/DNIS Service Options
828 Programming Aspila EX Software Manual
34-09 : ANI/DNIS Service Options
Description
Use Program 34-09 : ANI/DNIS Service Options to define theANI//DNIS service option setup
for E&M Class of Service.
Input Data
Level:
Aspila EX
IN •Available.
Class of Service 01-15
Item
No.
Name Input Data
Default
Related
Program
COS 01-14 COS 15
01 Receive Format
Use this option to specify the format of the
ANI/DNIS data reeceived from the telco.
Make sure your entry is compatible with the
service the telco provides. (The character *
indicates a deliminter.)
0 = Adress
1 = *ANI*
2 = *DNIS*
3 =
*ANI*Address*
4 = *ANI*DNIS*
5 = *DNIS*ANI*
(* = Delimiter
Code)
0 0 34-09-02
02 Delimiter Dial Code
This option defines the character telco uses
as a delimiter (see entries 1-9 in Item 1
above). Valid entries are 0-9, #, and *.
1-9, 0, *, # * * 34-09-01
03 Route Setup of Receive Dial
This option specifies the source of the data
the system uses to route incoming ANI/
DNIS calls.
0 = Fixed Route
(Item 08)
1 = Routes on
Received DNIS or
Address Data
2 = Routes on
Received ANI
Data
0 0 34-09-04
34-09-08
04 Route Table Setup of Target Dial
The option sets how the system uses the
route data (gather in Item 3) to route incom-
ing ANI/DNIS calls).
0 = ABB Table
(Program 13-03)
1 = DID Table
(Program 22-11)
0 0 13-04
22-11
34-09-05
05 ANI/DNIS Display as Target Dial Name
Use this option to set if ANI data should
appear on telephone displays as part of
Caller ID display.
0 = Display Off
1 = Display On
1 0 13-04
20-09-02
22-11-03
23-09-04