Program 90 : Maintenance Program
90-10 : System Alarm Setup
1038 Programming Aspila EX Software Manual
90-10 : System Al arm Setup
Description
Use Program 90-10 : System Alarm Setup to assign a status to system alarms. You can designate
an alarm as Major or Minor. This program also assigns whether or not the alarm is displayed to a
key telephone and whether or not the alarm information is reported to the pre-defined destination.
Input Data
Default
Level:
Aspila EX
IN •Available.
Alarm Number 001-100
Item No. Item Input Data
01 Alarm Type 0- Not set
1- Major Alarm
2- Minor Alarm
02 Report 0- Not report (No auto-dial)
1- Report (auto-dial)
Alarm Type Report Note
Is Used To
Advise of . . .
Action
1 2 (MIN) 0 Board Initialization
Error
Initialization failure or the
PCB is defective.
Remove and reinstall the PCB.
If RECover message is received
in the alarm report, the PCB is
good. If not, replace with a new
PCB.
2 2 (MIN) 0 Board Initial Test
Error
PCB initial test failure or the
PCB is defective.
Remove and reinstall the PCB.
If RECover message is received
in the alarm report, the PCB is
good. If not, replace with a new
PCB.
3 2 (MIN) 0 Board Installation
Error
PCB was unplugged without
using the proper procedure.
Check the PCB installation.
4 2 (MIN) 0 Communication Error
Between Board and
NTCPU
PCB communication failure
has occurred.
Remove and reinstall the PCB.
If RECover message is received
in the alarm report, the PCB is
good. If not, replace with a new
PCB.
To Next Page
Loading...
