NEC ASPILA EX - Page 917

Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
Aspila EX Software Manual Programming 911
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS)/F-Route
Telephone Programming Instructions
To enter data for Program 44-02 (Dial Analysis Table for ARS/F-Route Access):
1. Enter the programming mode.
2. 44 02
3. Enter the number of the item you want to program.
4. Select the Analyze Table number to be programmed by pressing the FLASH or the VOLUME
p or VOLUME q keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press MSG once to enter a new item number.
OR
Press MSG until you’ve exited that series’s programming section.
03 Additional Data • 1- 0-255 (Delete Digit)
(255 : delete all digit)
•2- [Program 44-01 : 0]
0-500 (ARS/F-Route table Number)
(0 : No setting) <Refer to Program 44-05>
[Program 44-01 : 1]
0-500 (ARS/F-Route select table Number)
(0 : No setting) <Refer to Program 44-04>
• 3- 0-4 (Dial Extension Analyze Table Number)
(0 : No setting) <Refer to Program 44-03>
0
04 Dial Tone Simulation 0- off
1- on
0
44-02-01 Analyze TBL1
Dial
back
 ¯ select
44-02-nn Analyze TBLnnn
nnnnn
¬ ®
Item No. Item Input Data Default