NEC ASPILA EX - Page 151

Conference
Aspila EX Software Manual Features 137
Programming
• 10-07-01 : Conversation Record Circuits
Determine if there are conference circuits available, that not all have been assigned as conver-
sation record circuits.
• 11-12-08 : Service Code Setup (for Service Access) - Barge In
If required, use this program to change the code users dial to Barge In to a Conference call.
This code is normally 810.
• 11-12-47 : Service Code Setup (for Service Access) - Call Waiting Answer / Split Answer
for SLT
If required, use this program to change the code users dial to Split while on a Conference call.
This code is normally 894.
• 11-16-02 : Program 11-16 : One-Digit Service Code Setup - Barge In
If required, use this program to define the single digit service code users dial to Barge In to a
Conference call.
• 14-01-04 : Basic Trunk Data Setup - Transmit Gain Level for Conference and Transfer
Calls
CODEC gain set at 0 dB (14-01-04 = 32) can be used to set the CODEC gain type for multi-
line Conference calls.
• 15-07-01 : Programming Function Keys
Assign a function key for Conference (code 07).
• 20-06-01 : Class of Service for Extensions
Assign a Class Of Service (1-15) to an extension.
• 20-13-08 : Class of Service Options (Supplementary Service) - Conference
In an extension’s COS, enable (1) or disable (0) the extension’s ability to initiate a Conference.
• 20-13-15 : Class of Service Options (Supplementary Service) - Barge In Initiate
In an extension’s COS, enable (1) or disable (0) the extension’s ability to Barge In to a call.
• 20-13-16 : Class of Service Options (Supplementary Service) - Barge In Receive
In an extension’s COS, enable (1) or disable (0) the extension’s ability to receive a Barge In on a
call.
• 20-14-11 : Class of Service Options For DISA/E&M - DISA/Tie Trunk Barge In
Determine if DISA and tie trunk users should have the ability to dial a service code to Barge
In to a Conference call (0=disabled, 1=enabled).