Name Storing
266 Features Aspila EX Software Manual
Operation
To program an extension’s name:
1. Press idle CALL key.
2. Dial 800
OR
Press Extension Name Change key (PGM 15-07 or SC 851: 55).
3. Enter the extension number to be named.
4. Enter name (see below).
Your name can be up to 12 digits maximum.
5. Press HOLD.
6. Press SPK to hang up.
When entering names in the procedures below, refer to this chart. Names can
be up to 12 digits long.
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | }
¬ ®
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, a-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ‘ ( )
* Enter characters:
* + , - . / : ; < = > ?
# # = Accepts an entry (only required if two letters on the same
key are needed - ex: STA). Pressing # again = Space.
CONF Clear the character entry one character at a time.
FLASH Clear all the entries from the point of the flashing cursor
and to the right.
To Next Page
Loading...
