Program 14 : Trunk Basic Setup
14-02 : Analogue Trunk Data Setup
544 Programming Aspila EX Software Manual
Conditions
None
07 DP to DTMF Conversion Options
Determine how a user can convert a Dial Pulse (DP)
call to a DTMF call. For each trunk, set the type of
DP to DTMF conversion required. There are three
conversion options: Automatic (0), Automatic and
Manual (1), or Manual (2).
Automatic:
DP to DTMF conversion occurs automatically if the
extension user waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs automatically if the
extension user waits more than 10 seconds before
dialing the next digit. In addition, the user can dial #
to switch a DP trunk to DTMF dialing.
Manual:
User can dial # to switch a DP trunk to DTMF dial-
ing
0 - Automatic
1 - Automatic and Manual
2 - Manual
2 21-01-03
08 Answering condition 0- Polarity reversing
1- Polarity reversing
or timer
0 21-01-03
09 Busy Tone Detection 0- disable
1- enable
0
10 Caller ID
Enable or disable a trunk’s ability to receive Caller
ID information.
0- disable
1- enable
0
11 Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the system’s abil-
ity to skip over a trunk if dial tone is not detected.
This option pertains to calls placed using Loop
Keys, Speed Dial, ARS, Last Number Redial or
Save Number dialed. It does not pertain to line key
or Direct Trunk Access calls.
0- disable
1- enable
0
12 Detect Network Disconnect Signal 0- disable
1- enable
0
13 Trunk-to-Trunk Limitation 0- disable
1- enable
0
14 Loop Start/Ground Start 0=Loop Start
1=Ground Start
0
Item
No.
Item Input Data Default
Related
Program
To Next Page
Loading...
