Program 20 : System Option Setup
20-14 : Class of Service Options for DISA/E&M
Aspila EX Software Manual Programming 635
Conditions
None
Feature Cross Reference
• Class of Service
• Direct Inward System Access (DISA)
• Tie Lines
Telephone Programming Instructions
To enter data for Program 20-14 (Class of Service Options for DISA/E&M):
1. Enter the programming mode.
2. 20 14
3. Enter the number of the item you want to program.
4. Select the Class of Service number to be programmed by pressing the FLASH or the VOL-
UME
p or VOLUME q keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press MSG once to enter a new item number.
OR
Press MSG until you’ve exited that series’s programming section.
09 Forced Trunk Disconnect <Not for ISDN T-point>
This option enables or disables a tie trunk caller’s ability to use
Forced Trunk Disconnect (Service Code *26). This option is not
available to DISA callers.
0-Off
1-On
00
10 Call Forward Setting by Remote Via DISA 0-Off
1-On
00
11 DISA/Tie Trunk Barge In
This option enables or disables a DISA or tie trunk caller’s ability to
use the Barge In feature.
0-Off
1-On
00
20-14-01 FCTN Cls1
Del._1digit_Dial O:Of
back
¯ select
20-14-nn FCTN Clsnn
nnnnn
¬ ®
Item
No.
Item
Input
Data
Default
COS 01-14 COS 15
To Next Page
Loading...
