Abbreviated Dialing
Aspila EX Software Manual Features 53
6. Enter the name associated with the Abbreviated Dialing number.
7. Press HOLD
8. Press SPK to hang up.
To dial a Common Abbreviated Dialing number:
1. At system phone, press idle CALL key.
OR
At single line set, lift handset.
2. Dial 813.
OR
Press DIAL key.
OR
Press Common Abbreviated Dialing key (PGM 15-07 or SC 851: 27).
To preselect, press a line key in step 1 (instead of CALL) before pressing the DIAL or
Abbreviated Dialing key)
3. Dial Common Abbreviated Dialing storage code.
The stored number dials out.
Unless you preselect, Trunk Group Routing selects the trunk for the call. The system
may optionally select a specific Trunk Group for the call.
If you have a DSS Console, you may be able to press a DSS Console key to chain to a
stored number.
When entering names in the procedures below, refer to this chart. Names can
be up to 12 digits long.
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | }
¬ ®
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, a-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ‘ ( )
* Enter characters:
* + , - . / : ; < = > ?
# # = Accepts an entry (only required if two letters on the same
key are needed - ex: STA). Pressing # again = Space.
CONF Clear the character entry one character at a time.
FLASH Clear all the entries from the point of the flashing cursor
and to the right.
To Next Page
Loading...
