NEC UNIVERGE NEAX 2000 IPS - [Cm07] Dti;Ccis;Isdn;Cft;Sip Trunk Assignment

– 85 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
DTI/CCIS/ISDN/CFT/SIP TRUNK ASSIGNMENT
07
FUNCTION:
This command is used to assign the DTI/CCIS/ISDN/CFT/SIP trunks.
PRECAUTION:
(1) This command requires a system reset after data setting.
(2) The system allocates time slots to consecutive channels from lowest to highest channel number
assigned. To minimize the number of time slots allocated, assign trunk numbers to the consecutive
channels on each card.
Never skip channels in this command.
ASSIGNMENT PROCEDURE:
DATA TABLE:
INITIAL
ST
EXE++ +
+
07YY
2ND DATA
DE
1
S
T DATA
(4 digits) (4 digits)
++
DE
: Initial Data
Y
1ST DATA 2ND DATA
RELATED
COMMAND
DATA MEANING DATA MEANING
01 XX ZZ Channel No. of Digital Trunk Inter-
face/CCIS
(PN-24DTA-C/PN-24PRTA/
PN-24CCTA/PN-30DTC-C/
PN-30PRTA/PN-30CCTA/
PN-8IPTA/PN-DTA/PN-DTB)
XX : AP No. (04-15, 20-31)
ZZ : Channel No.
PN-24DTA-C/PN-24PRTA/
PN-24CCTA: 00-23
PN-30DTC-C/PN-30PRTA/
PN-30CCTA/PN-DTA/
PN-DTB: 01-31 NOTE 1
CFTC/8IPTA: 00-31
D000
D255
NONE
Trunk number NOTE 2
NOTE 3
No data
CM05
CM10/CM14
CM30
NOTE 1: For 30 DTI, do not assign Channel No. 00 that is used for Frame Alignment signal.
When Associated Interoffice Signaling is used, do not assign Channel No. 16 that is used for
signaling channel.
NOTE 2: Trunk numbers already assigned by CM10/CM14 should not be used.
NOTE 3: Do not assign Trunk number D255 for CCIS/SIP.
Continued on next page
~
JUNE/01/2007
CM07