NEC UNIVERGE NEAX 2000 IPS - [Cm64] Automated Attendant

– 497 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
AUTOMATED ATTENDANT
64
FUNCTION:
This command is used to define the answering system of the Automated Attendant feature.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
NOTE 1: If no tone connection is required, Dial Tone sending can be stopped by CM48 Y=2.
NOTE 2: When providing a Night Message for Automated Attendant, the 2nd data 08 of CM30 Y=30,
31 cannot be specified for handling of busy/not available Automated Attendant destination.
Continued on next page
ST
EXE
++ +
+
64Y
DATA
DE
TENANT NUMBER
(2 digits) (1-4 digits)
++
DE
: Initial Data
Y
TENANT
SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
0 Answering System for
Day Mode
00-63 00
01
02
03
DT connection
Hold Tone on MP card +
DT connection
1st Answering Message +
DT connection
DT connection
CM30 Y=02, 03
CM48 Y=2>06
CM41 Y=0>33, 43
CM45 Y=2
CM49
CM63 Y=2
1 Tenant Number for Music
on Hold
00
09
NONE
External Hold Tone
Source number assigned
by CM10/CM14
No data
CM10/CM14>DA00-
DA09
CM48
CM44
2 Answering System for
Night Mode
00
01
02
03
DT connection
Hold Tone on MP card +
DT connection
Night Message + DT
connection NOTE 2
As per CM64 Y=0
CM30 Y=02, 03
CM41 Y=0>33, 43
CM49 Y=00>02XX,
Y=02
CM64 Y=0
~
JANUARY/20/2006
CM64