NEC UNIVERGE NEAX 2000 IPS - [Cmd027] Call Charge Development Tables

– 846 – NWA-008844-001 Rev.5.0
91ch3009.fm
COMMAND CODE
TITLE:
CALL CHARGE DEVELOPMENT TABLES
D027
FUNCTION:
This command is used to assign the charging method to each dialed digit on the basis of each Develop-
ment Table designated by CMD026.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE++ +
+
D027
2ND DATA
DE
1ST DATA
(4 digits) (1-6 digits)
++
DE
: Initial Data
NOTE: The actual digits sent from a trunk should be assigned.
: Initial Data
NOTE: Charging will start when the number is dialed.
1ST DATA 2ND DATA
XXX Y
XXX: Development Table No. (000-511)
Y : Dialed digit (0-9, A(*), B(#))
NOTE
XXXXX Y
XXXXX: Various Data
Y : Attribute Data
Refer to the following table
VARIOUS DATA ATTRIBUTE DATA
DATA MEANING DATA MEANING
1 No charge
2 Charging is not available
0-511 Table No. for Next Development Table 3 Wait for next digit
X YY ZZ X : K-Method/H-Method=0/1
YY: Kind of charging (00-15)
ZZ : Charging Rank (00-15)
4 Charging Identification No.
0-9 Charging No. of Flat Rate assigned by
CMD004
6 With answer signal
A No answer signal NOTE
9 Send to SMDR terminal
10000 8 Charging by metering pulse
CMD027