NEC UNIVERGE NEAX 2000 IPS - [Cma9] D-Channel Assignment

– 624 – NWA-008844-001 Rev.5.0
91ch3007.fm
COMMAND CODE
TITLE:
D-CHANNEL ASSIGNMENT
A9
FUNCTION:
This command is used to assign the various data to each D-Channel Handler (DCH) for ISDN-Primary
Rate Interface/Roaming.
PRECAUTION:
This command requires the DCH card reset after data setting.
ASSIGNMENT PROCEDURE:
DATA TABLE:
DCH INITIAL
ST
EXE++ +
+
A9YY
DATA
DE
DCH No. (0-7/00-31)
(1-4 digits)
++
DE
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
00 Trunk used as D-Channel number
0-7
000
255
NONE
DCH/PRT trunk number assigned
by CM07 Y=01
No data
CM05 Y=0: 36
CM06 Y=08
CM07 Y=01
CM35 Y=93
Trunk used as D-Channel number
00-31
[Series 3800]
000
511
NONE
DCH/PRT trunk number assigned
by CM07 Y=01
No data
NOTE: Second data 256-511 can be set only when PN-24PRTA/PN-30PRTA/PN-DTA/PN-DTB card is
accommodated in a remote site.
01 Home PBX ID for indication on
PS/D
term
for Roaming
[For PCS]
X
XXXX
NONE
Home PBX ID
No data
Own office number sent with the
answering station number for Q-
SIG network
0
999
NONE
Own Office number
No data
~ ~ ~ ~
JUNE/01/2007
CMA9