CHAPTER 2 PRECAUTION
– 24 – NWA-008844-001 Rev.5.0
91ch2001.fm
CONDITIONS FOR USING COMMANDS
(1) Some commands require a system reset after data setting, and others cannot be assigned/changed
unless the system is in off-line mode (a state in which call processing is at a halt).
These commands are shown in the following table, categorized according to the conditions for their
use.
(2) When deleting data in any command, enter “CCC” as the 2nd data. However, data in the following
commands cannot be deleted.
• Commands where the initial data ( ) is provided but the initial data ( ) is “NONE”.
• CM29, CM41, CM42, CM46, CM47, CM60 Y=30.
CONDITIONS FOR USING COMMANDS
To Next Page
Loading...
