NEC UNIVERGE NEAX 2000 IPS - [Cm1 D] Ps-ID Assignment;Ps Operation Data Download; Wlan Station Data Assignment

– 285 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
PS-ID ASSIGNMENT/PS OPERATION DATA DOWNLOAD/
WLAN STATION DATA ASSIGNMENT
1D
FUNCTION:
This command is used to assign the PS-ID, to download the PS operation data and WLAN station data.
PRECAUTION:
(1) When a PS is set up initially, set the PS in Data Download Mode by applying power to the PS while
pressing the SEND key, and then execute the CM1D Y=20 in Calling Area No. 00.
(2) It takes 10 seconds to load the PS operation data to the PS.
(3) The following items display on the MAT.
STATUS DISPLAY
Loading succeeded OK
PS is busy WAIT BUSY NOW
PS is out of area WD ERROR
Lack of PS data DATA ERROR
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE++ +
+
1DYY
SETTING DATA
DE
PS/WLAN STATION No.
(1-8 digits) (1-9 digits)
++
DE
: Initial Data
Y
PS STATION No.
SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
01 Subline PS number to each
Primary PS station
X-XXXXXXXX
(Primary PS Sta-
tion No.)
X-
XXXXXXXX
NONE
Subline PS Station No.
X: 0-9, A (*), B (#)
No data
CM1C
14 Terminal type of PS
[For PHS]
X-XXXXXXXX
(Primary/Subline
PS Station No.)
0
1
PHS
Not used
CM1C
Terminal type of WLAN
Station
[Series 3600]
X-XXXXXXXX
(WLAN Station
No.)
0
1
PHS
Not used
CM1C
Continued on next page
NOVEMBER/15/2006
CM1D