– 489 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
ATT TENANT GROUP, FUNCTIONS
60
FUNCTION:
This command is used to assign a number to an Attendant Console for access on a tenant basis, and de-
fine the consoles’ night switching ability, off-hook ringing, tone ringer, password code for Attendant
Lockout and Attendant Programming.
PRECAUTION:
(1) After setting CM60 Y=00, 01, 02, 04, 06, 22, system reset is required.
(2) The data for each Attendant Console type is shown below.
*: CM60 Y=23 is only available for DESKCON.
(3) When assigning a password code for ATTCON/DESKCON by CM60 Y=30, the Function number
(0/1) is required as the first data. The purpose of Function numbers is shown below.
0: To assign a password for Attendant Lockout
1: To assign a password for Attendant Programming the following features:
Remote Access to System (DISA), Speed Calling-System (System Speed Dialing), Date and
Time, Choice of Night Service and Tone Ringer
ASSIGNMENT PROCEDURE:
×: To assign –: Not assigned
Y
KIND OF
ATTCON
00 01 02 04 06 16 17 22 23 26 27 30 32 33 34
Large type ATTCON ×××××––––× –––––
ATTCON/DESKCON ×××××××××*– ×××××
+ 60YY + +
ATTCON
++ +
NUMBER
DATA
(0-7)
EXE
ST
DEDE
FUNCTION
NUMBER
(0/1)
(1-8 digits)
+ 6030 + + + + +
DATA
EXE
ST
DEDE
FUNCTION
NUMBER
(0/1)
(1-8 digits)
NOVEMBER/15/2006
CM60
To Next Page
Loading...
