NEC UNIVERGE NEAX 2000 IPS - [Cm51] Automatic Transfer Destinations

– 469 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
AUTOMATIC TRANSFER DESTINATIONS
51
FUNCTION:
This command is used to define destinations for different types of diversion.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
+ 51YY + +
GROUP
++ +
NUMBER
DATA
(2 digits)
EXE
ST
DEDE
(1-8 digits)
: Initial Data
Y GROUP NUMBER SETTING DATA
No.
MEANING
DATA MEANING DATA MEANING
00 Transfer destination of incoming call when a
station does not answer the call within a pre-
determined time (for DID call)
See CM41 Y=0>01, CM49 Y=00: 0D00
00
63
Tenant 00
Tenant 63
X
XXXXXXXX
or
E000
or
EB000
EB127
NONE
Station No.
Attendant Console
Digital Announce-
ment Trunk No.
assigned by
CM10/CM14
No data
01 Same as CM51 Y=00 (for Tie Line call)
03 Transfer destination of incoming call when a
station is busy (for DID call)
See CM49 Y=00: 0E00
04 Same as CM51 Y=03 (for Tie Line call)
06 Transfer destination of incoming call when an
unassigned number is dialed (for DID call)
(Effective when CM08>032 is 1)
See CM08>032, CM49 Y=00: 0A00
07 Same as CM51 Y=06 (for Tie Line call)
(Effective when CM08>032 is 1)
See CM08>032
Continued on next page
~ ~ ~~
JUNE/01/2007
CM51