CHAPTER 3 COMMAND DESCRIPTION
– 44 – NWA-008844-001 Rev.5.0
91ch3001.fm
HOW TO READ THIS CHAPTER
Information about each command is presented in the following order:
(1) FUNCTION: The function of the command.
(2) PRECAUTION: Precautions related to assigning data.
(3) ASSIGNMENT PROCEDURE: The procedure for assigning data in CAT mode.
(4) DATA TABLE: Detailed descriptions of the data.
In the description of each command, the following symbols are used.
: Initial data which is automatically loaded into the memory, after system initialization
by setting position “B” on SW3 of the MP, followed by a reset.
: Commands which require a reset of the MP card after data setting.
: Commands which require a reset of the AP00 card after data setting.
: Commands which can be used only under Off-Line mode of the MP card.
To set Off-Line mode,
(1) Set SW3 on the MP card to “2” or “3”.
(2) Press SW1 on the MP card.
: Commands which can be used only under Off-Line mode of the AP00 card.
: Commands which require a reset of the CSH card after data setting.
: Commands which require a reset of the DCH card after data setting.
: Commands which require a reset of the ICH card after data setting.
: Commands which require a reset of the DTI/BRT/PRT/CCT card after data setting.
: Commands which require a reset of the CFTC card after data setting.
: Commands which require a reset of the IPT card after data setting.
: Commands which require a reset of the SIP card after data setting.
: Commands which require a reset of the IP-PAD card after data setting.
: Commands which require a reset of the BRT card after data setting.
: Commands which require a reset of the CIR card after data setting.
Refer to Chapter 4 for details on default data when the Resident System Program is loaded by setting po-
sition “C” on SW3 of the MP, followed by a reset.
You should confirm the meaning of initial data, and change or delete the data, if required.
INITIAL
AP00 INITIAL
OFF LINE
AP OFF LINE
CSH INITIAL
DCH INITIAL
ICH INITIAL
DTI INITIAL
CFT INITIAL
IPT INITIAL
SIP INITIAL
IP-PAD INITIAL
BRT INITIAL
CIR INITIAL
DECEMBER/02/2005
HOW TO READ THIS CHAPTER
To Next Page
Loading...
