NEC UNIVERGE NEAX 2000 IPS - [Cm14] Station Number, Trunk Number, Card Number for each Fp

– 232 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, CARD NUMBER FOR EACH FP
14
FUNCTION:
This command is used to assign station numbers, trunk numbers, and card numbers to LEN (Line Equip-
ment Number: FP/Virtual AP No. + AP/Virtual PIM Port No.).
PRECAUTION:
[Series 3200 R6.2 (R6.2)]
(1) The first data of CM14 is as follows.
Assign the correct FP/AP number to each FP/AP, referring to tables below.
[For Series 3200 R6.1 software or before]
×: Available –: Not available
[For Series 3200 R6.2 software]
×: Available –: Not available
FP/AP No.
FP/AP TYPE
00 01-03 04-15 16-19 20-31 32-59 60-63
FP card (PN-CP15) – × – × –––
MP built-in FP × ––––––
DAIA/DAID card – × – × –––
Virtual FP for D
term
IP – × – × –––
AP card – – × – × ––
Virtual AP (Virtual IPT) – – × – × ––
FP/AP No.
FP/AP TYPE
00 01-03 04-15 16-19 20-31 32-59 60-63
FP card (PN-CP15) – × – × –––
MP built-in FP × ––––––
Virtual FP for D
term
IP – ××××––
AP card – – × – × ––
Virtual AP (Virtual IPT) – – × – × ––
Continued on next page
CM14