CHAPTER 1 HOW TO USE CAT
– 17 – NWA-008844-001 Rev.5.0
91ch1001.fm
The examples of data setting is described below.
(1) Example in the case that station number 300 is to be assigned to LEN000 and station number 301 to
LEN001 by CM10.
Example of CAT Operation
NOTE 1: When no data exists, “NONE” is displayed. And when data exists, that data is displayed.
NOTE 2: This operation is for confirming the data assignment. You can omit this step.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
STEP 13
STEP 14
Set CAT mode.
Press ST .
Enter "10" (Command Code).
Press DE .
Enter "000" (LEN).
Press DE .
Enter "300" (Station Number).
Press EXE .
Press DE .
Press S .
Enter "301" (Station Number).
Press EXE .
Press DE .
Lift handset, then replace it.
CAT MODE
COMMAND =
COMMAND = 10
10 >
10 > 000
10 > 000: NONE−
10 > 000: NONE−300
OK
10 > 000: 300 −
10 > 001: NONE
10 > 001: NONE−301
OK
10 > 001: 301
(Display)
NOTE 1
NOTE 2
NOTE 1
NOTE 2
DE
CAT OPERATION
To Next Page
Loading...
