NEC UNIVERGE NEAX 2000 IPS - [Cm62] Tenants for each Att Group

– 495 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
TENANTS FOR EACH ATT GROUP
62
FUNCTION:
This command is used to assign which tenants are handled by each ATTCON Group.
PRECAUTION:
(1) This command requires a system reset after data setting.
(2) Multiple tenants can be assigned to one ATT Group, but one tenant cannot be assigned to more
than one ATT Group.
ASSIGNMENT PROCEDURE:
DATA TABLE:
INITIAL
ST
EXE
++ +
+
62Y
DATA
DE
TENANT NUMBER
(2 digits) (1 digit)
++
DE
: Initial Data
Y TENANT SETTING DATA
RELATED
COMMAND
No. MEANING No. MEANING No. MEANING
0
1
2
3
ATT Group 0
ATT Group 1
ATT Group 2
ATT Group 3
00
63
Tenant 00
Tenant 63
0
1
To handle
Not handled
CM60 Y=00
~ ~
CM62