CHAPTER 1 HOW TO USE CAT
– 20 – NWA-008844-001 Rev.5.0
91ch1001.fm
ERROR MESSAGES
When an operation is incorrect, or wrong data is entered, an error message is displayed on the LCD. Error
messages and their meanings are shown below.
Error Messages
ERROR MESSAGE MEANING OF MESSAGE ACTION
DIGIT ERROR Error in the number of digits entered Depress “ST” or “CE” and enter the
correct data.
DATA ERROR The value of the entered data is
incorrect.
Depress “ST” or “CE” and enter the
correct data.
CODE NOT USED The command code entered is not in
use, or password is needed.
Depress “ST” or “CE” and enter the
correct data, or follow the procedure
for entering a password.
DATA NOT FOUND A station number not assigned has
been entered.
Depress “ST” or “CE” and enter the
correct data.
WAIT BUSY NOW The station or trunk, for which data
is to be changed, is busy.
Wait until it becomes idle.
ASSIGNED ALREADY This error message is displayed when
not enough digits are entered. For
example, when assigning “12” for a
service access code, even if “123”
has been already used for another
service access code.
Depress “ST” or “CE” and enter the
correct data.
HARDWARE ERROR Memory read/write disabled. Check the switch setting of MP card
or replace the MP card with spare.
WD ERROR - Error exists in memory.
- System ID Code has not been
assigned.
- Option is not allowed.
Assign correct System ID Code.
Continued on next page
ERROR MESSAGES
To Next Page
Loading...
