NEC UNIVERGE NEAX 2000 IPS - [Cmb1] Traffic Measurement

– 661 – NWA-008844-001 Rev.5.0
91ch3007.fm
COMMAND CODE
TITLE:
TRAFFIC MEASUREMENT
B1
FUNCTION:
This command is used to measure traffic data of outgoing/incoming trunk calls and to display the data
on CAT or MAT.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE
++ ++
B1Y 2ND DATA
DE
1ST DATA
++
DE
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA NEANING
0 Setting of traffic
measurement condition
0 Traffic Measurement
Mode
0
1
2
3
4
No measurement
Traffic measurement per
hour
Traffic measurement per
day
Traffic measurement per
hour continuously
[Series 3900]
Traffic measurement per
day continuously
[Series 3900]
NOTE: Traffic Measurement start time and end time settings by CMB1 Y=0>1, 2
are required to set the second data 1 and 2.
Continued on next page
JUNE/01/2007
CMB1