NEC UNIVERGE NEAX 2000 IPS - [Cmac] Isdn Functions

– 632 – NWA-008844-001 Rev.5.0
91ch3007.fm
COMMAND CODE
TITLE:
ISDN FUNCTIONS
AC
FUNCTION:
This command is used to assign the functions to the ICH/BRT card.
PRECAUTION:
This command requires system reset after data setting.
ASSIGNMENT PROCEDURE:
DATA TABLE:
INITIAL
ICH No./ISDN DCH No.
+
ST
++
ACYY
++
DATA
DE
EXE
+
(00-15)
DE
(1-8 digits)
+
ISDN LINE No.
(0-7)
AP No.
+
ST
++
AC30
++
ISDN
DE
EXE
+
(04-15,
DE
(4 digits)
+
BCH No.
(0-7)
SUBSCRIBER No.
+
(4 digits)
SPID
20-31)
: Initial Data
Continued on next page
YSETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
00 ISDN Line station number to be con-
trolled
X
XXXXXXXX
ISDN Line station number
01 Layer 2 data link 0
1
Point-to-Point connection
Point-to-Multipoint connection
02 TEI (Terminal Endpoint Identifier) 0
1
Manual TEI assignment
Automatic TEI assignment
03 Passive Bus in Point-to-Multipoint con-
nection
0
1
Extended Passive Bus
Short Passive Bus
04 Layer 1 activation 0
1
Always activated
Activated by call event
06 Checking of TEI (Terminal End-point
Identifier) when Layer 2 data link is
released
0
1
To provide
Not provided
10 National ISDN-1 mode
[North America Only]
0
1
To provide
Not provided
~
NOVEMBER/15/2006
CMAC