NEC UNIVERGE NEAX 2000 IPS - [Cme6] Call Forwarding Set;Reset from Mat;Cat

– 722 – NWA-008844-001 Rev.5.0
91ch3008.fm
COMMAND CODE
TITLE:
CALL FORWARDING SET/RESET FROM MAT/CAT
E6
FUNCTION:
This command is used to set/reset Call Forwarding service to each station from a MAT/CAT.
PRECAUTION:
CME6 can be used for any station irrespective of its state.
ASSIGNMENT PROCEDURE:
DATA TABLE:
NOTE: To reset the Call Forwarding, assign “CCC” to the second data.
Continued on next page
CCC
+
ST + +E6YY EXE+
(for reset)
DE
STATION No.
(1-8 digits)
+DE
DESTINATION No.
(1-26 digits)
+
: Initial Data
Y MEANING DESTINATION
00 Call Forwarding-All Calls • Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
X-XXXX + + YY...YY
X-XXXX: Outgoing Trunk/LCR Group Access Code (1-4 digits)
: Separate Mark
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
NONE
: No data
01 Call Forwarding-Busy Line
02 Call Forwarding-Don’t Answer (No
Answer)
03 Call Forwarding-Busy Line/Don’t
Answer (No Answer)
04 Split Call Forwarding-All Calls 0: Destination for Split Call Forwarding (Block 0)/ATT
1: Destination for Split Call Forwarding (Block 1)
2: Destination for Split Call Forwarding (Block 2)
3: Destination for Split Call Forwarding (Block 3)
4: Destination for Split Call Forwarding (Block 4)
5: Destination for Split Call Forwarding (Block 5)
6: Destination for Split Call Forwarding (Block 6)
7: Destination for Split Call Forwarding (Block 7)
8: Destination for Call Forwarding
9: Destination for Speed Calling-Station (Station Speed Dialing) (Block 0)
NONE
: No data
05 Split Call Forwarding-Busy Line/
Don’t Answer (No Answer)
,
,
See
CM78
JANUARY/20/2006
CME6