– 723 – NWA-008844-001 Rev.5.0
91ch3008.fm
COMMAND CODE
TITLE:
CALL FORWARDING SET/RESET FROM MAT/CAT
E6
: Initial Data
Y MEANING DESTINATION
06 Call Forwarding-PS/WLAN Termi-
nal Out of Cell (Zone)
[Series 3100]
• Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
X-XXXX + + YY...YY
X-XXXX: Outgoing Trunk Access Code (1-4 digits)
: Separate Mark
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
NONE
: No data
Call Forwarding-Logout (D
term
IP)
[Series 3100]
07 Timing of Call Forwarding-Don’t
Answer (No Answer) for a trunk
incoming call on a station basis
[Series 3200 R6.2 (R6.2)]
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
: As per CM41 Y=0>100
08 Timing of Call Forwarding-Don’t
Answer (No Answer) for an internal
call or an assisted call on a station
basis
[Series 3200 R6.2 (R6.2)]
001: 0-4 seconds
(4 seconds increments)
120: 116-120 seconds
NONE
: As per CM41 Y=0>101
50 Trunk number link up with a
Mobility Access station number
[Series 3700 R12.1]
• Trunk number=Mobile phone No. (Maximum 26 digits)
NONE
: No data
NOTE 1: Station number cannot be assigned to second data.
NOTE 2: When the mobile phone number has been already assigned to other station number, “ASSIGNED
ALREADY” is displayed.
NOTE 3: Outgoing Trunk Access Code (1-4 digits) must be assigned by CM64 Y=10.
NOTE 4: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=51 as the 2nd data.
51 Destination of ISDN Alternative
Routing of in Remote PIM survival
mode (station basis)
[Series 3700 R12.2]
• Destination C.O. line number (Maximum 26 digits)
NONE
: No data
NOTE 1: When the system operates both CME6 Y=50 and CME6 Y=51, set the same number of the 2nd data of
CME6 Y=50 as the 2nd data.
NOTE 2: When 2nd data of CM64 Y=12 is set to “0”, the destination is set by this command.
,
,
~ ~
JULY/01/2006
CME6
To Next Page
Loading...
