NEC UNIVERGE NEAX 2000 IPS - [Cmdd10] Interface Condition for Ap00 Rs Port

– 873 – NWA-008844-001 Rev.5.0
91ch3009.fm
COMMAND CODE
TITLE:
INTERFACE CONDITION FOR AP00 RS PORT
DD10
FUNCTION:
This command is used to assign the interface conditions of the RS port for SMDR with NEAX 2400 IMS
Format/MCI when using PN-AP00-B/PN-AP00-D with MRCA program.
[Series 3300]
PRECAUTION:
Initial data of CMDD10 is based on CMDD01>100-103. Refer to the following tables for the initial data.
ASSIGNMENT PROCEDURE:
AP00 INITIAL
SMDR with NEAX
2400 IMS Format
(CMDD01>100-103: 3)
MCI
(CMDD01>100-103: 10)
PMS
(CMDD01>101/103: 12)
Equipment Type (X00) 1 (SMDR terminal 0)
–
6 (External printer)
Data Speed (X01) 2 (1200 bps) 5 (9600 bps) 2 (1200 bps)
Stop Bit Length (X02) 2 (2 bits) 2 (2 bits) 2 (2 bit)
Data Length (X03) 1 (8 bit) 0 (7 bit) 1 (8 bit)
Parity (X04)
0 (No Parity) 0 (No Parity) 0 (No Parity)
Station Address (SA) (X05) 48 (0) 48 (0) 0 (80 digits)
Unit Address (UA) (X06) 33 (!) 33 (!)
–
Send the text to the VMS
when the AP00 card is reset
(X07)
–
0 (To sent)
–
Number of digits for station
number in the message format
to communicate with the
VMS (X08)
–
0 (6 digit)
–
Message Format (X09)
–
0
(Basic Format (without
ANI))
–
Message Format (X10) 0
(Former NEAX 2400 IMS
Format)
––
Guard Timer between texts
(X17)
–
5 (512-640 ms.)
–
ST
EXE++ +
+
DD10
2ND DATA
DE
1ST DATA
(3 digits) (1-2 digits)
++
DE
JULY/01/2006
CMDD10