– 196 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, CARD NUMBER
10
FUNCTION:
This command is used to assign station numbers, trunk numbers, and card numbers to LEN (Line Equip-
ment Number: PIM No. + Port No.).
After Series 3200 R6.2 (R6.2) or later, all the data of CM10 can also set up CM14.
While using Series 3200 R6.2 (R6.2) or later, Station number/Trunk number/Card number recommends
setting up by CM14.
PRECAUTION:
(1) LEN is determined by setup of CM05 Y=0/4/6/8, refer to “LEN ASSIGNMENT” about location
of LEN at the initial setting. Page A2
(2) When deleting a station number (Single Line or D
term
), be sure to delete Call Pickup data (CM16),
ACD/UCD Group data (CM17) and Station Hunting Group data (CM18) in advance.
(3) When assigning Conference Trunk (ED00-ED03), a system reset is required after data setting.
(4) After assigning the data for PN-8RST (DTMF receiver), PN-2CSI/PN-4CSI (CSI), PN-2ILCA
(ISDN Terminal), you must unplug the circuit cards, then plug them again (After unplugging the
circuit card, you must wait for 30 seconds before plugging the circuit card again.).
(5) 5 or more digits station number should not be assigned when the following features with AP00 are
used.
•SMDR/PMS
• Front Desk Terminal/D
term
TIMS (CIS)
(6) For LEN assignment, see “Location of Each LEN” Page 200
and “LEN Assignment on Each Line/Trunk Card”. Page 204
ASSIGNMENT PROCEDURE:
+10 + +
LEN (PIM No. + PORT No.)
++ +
STATION
EXE
ST
DEDE
(3 digits)
NUMBER
TRUNK
NUMBER
CARD
NUMBER
(1-10 digits)
JULY/01/2006
CM10
To Next Page
Loading...
