NEC UNIVERGE NEAX 2000 IPS - Page 221

– 197 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
STATION NUMBER, TRUNK NUMBER, CARD NUMBER
10
DATA TABLE:
LEN
SETTING DATA (STATION NUMBER, TRUNK NUMBER, CARD NUMBER)
RELATED
COMMAND
DATA MEANING OF DATA
000
763
(PIM
No. 0-7
+
Port No.
00-63)
X-XXXXXXXX Single Line station number (1-8 digits) X=0-9, A (*), B (#)
Virtual PS station number (1-8 digits)
CM12
CM13
C100
C163
Card number of AMP trunk (PN-2AMP)
When installed in PIM 0/1............. C100-C115
When installed in PIM 2/3............. C116-C131
When installed in PIM 4/5............. C132-C147
When installed in PIM 6/7............. C148-C163
CM38
C200
C203
Card number of Caller ID sender (PN-4RSTF/PN-4RSTF-A/PN-
4RSTH)
[North America Only]
CM04 Y=01>02
CM45 Y=5
D000
D255
Trunk number (C.O./Tie Line, Paging, Radio Paging, BGM, Virtual
trunk, 4VCT)
• For COT ..........................Maximum 64 lines per PIM
• For DIT............................Maximum 48 lines per PIM
• For LDT/ODT .................Maximum 24 lines per PIM
• For TNT (BGM)..............Maximum 10 lines per system
NOTE 1: Trunk numbers already assigned by CM07 should not be
used.
NOTE 2: Do not assign Trunk number D255 for CCIS/IP.
CM07
CM30
CM35
DA00
DA09
Card number of External Hold Tone Interface (0-9) for Music on Hold
(TNT/COT)
CM44
CM48
CM12 Y=04
DB00
DB09
Card number of External Announcement Machine Interface (0-9) for
Wake Up service
CM44
CM48
DD000
DD731
IP-PAD (PN-32IPLA/PN-32IPLA-A) number
DD X ZZ
X : Card No. of IP-PAD (0-7)
ZZ: Channel No. of IP-PAD (00-31)
NOTE: When using Series 3200 R6.2 (R6.2) Software or later, set the
IP-PAD data by not CM10 but CM14.
CM0A Y=50
E000
E007
ATTCON/DESKCON number (0-7)
NOTE: ATTCON/DESKCON number should be different from Large
type ATTCON numbers assigned by CM06.
CM90
CM60
Continued on next page
~
~ ~~ ~~~ ~
DECEMBER/02/2005
CM10