NEC UNIVERGE NEAX 2000 IPS - [Cmaa] Dti;Cir;Dch;Ich;Brt;Prt;Cct;Cftc;Virtual Ap Functions

– 625 – NWA-008844-001 Rev.5.0
91ch3007.fm
COMMAND CODE
TITLE:
DTI/CIR/DCH/ICH/BRT/PRT/CCT/CFTC/VIRTUAL AP FUNCTIONS
AA
FUNCTION:
This command is used to assign the functions to the DTI, CIR, DCH, ICH, BRT, PRT, CCT, CFTC card,
and Virtual AP.
PRECAUTION:
(1) After setting CMAA Y=00-03, 09, 12, 13, the DTI reset is required.
Set the Make Busy switch of the DTI/PRT/BRT/CCT card to UP then DOWN.
(2) After setting CMAA Y=06, DTI/DCH/ICH reset is required.
Set the Make Busy switch of the DTI/PRT/BRT/DCH/ICH card to UP then DOWN.
(3) After setting CMAA Y=10, the CFT reset is required.
Set the Make Busy switch of the CFTC card to UP then DOWN.
(4) After setting CMAA Y=14, the system reset is required.
(5) Assign Virtual AP number for the 1st data of CMAA Y=14 (Providing Virtual AP with control
channel).
(6) AP number 64-93 can be set only for PRT card accommodated in a remote site.
ASSIGNMENT PROCEDURE:
DATA TABLE:
AP NUMBER/
+
ST
++
AAYY
++
DATA
DE
EXE
+
VIRTUAL AP NUMBER
(04-15, 20-31, 64-93)
DE
(1-2 digits)
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
00 Data Mode
(24 DTI/PRT/CCT)
0
1
Based on AT&T Specifications
Not Used
01 Frame Configuration
(24 DTI/PRT/CCT)
0
1
12-Multi Frame (D4)
24-Multi Frame (ESF)
Continued on next page
DTI INITIAL
DTI INITIAL
NOVEMBER/15/2006
CMAA