CHAPTER 1 HOW TO USE CAT
– 16 – NWA-008844-001 Rev.5.0
91ch1001.fm
CAT OPERATION
When setting the office data, it is necessary to enter the following three kinds of data.
• Command Code
•First Data
• Second Data
The operation is explained below.
(1) To confirm the existing office data
+ Command Code + + First Data +
With the above entry completed, the present second data is displayed on the LCD.
If the second data is not assigned yet, either the initial data value or “NONE” is displayed.
(2) To assign (change) the office data
+ Command Code + + First Data + + Second Data +
With pressed, “OK” is displayed on the LCD.
To confirm the data assigned, press after entering the fist data.
(3) Use of button and button
• If is pressed after setting the second data (after has been pressed), the next first data
is displayed.
• If is pressed after setting the second data (after has been pressed), the last data is
displayed.
ST DE DE
ST DE DE
EXE
EXE
DE
S –
S
EXE
–
EXE
JULY/01/2006
CAT OPERATION
To Next Page
Loading...
