CHAPTER 4 RESIDENT SYSTEM PROGRAM
– 886 – NWA-008844-001 Rev.5.0
91ch4001.fm
HOW TO LOAD RESIDENT SYSTEM PROGRAM
STEP1: On the MP card, set the SW3 to “C”, then press the SW1.
STEP2: After 30-40 seconds, confirm the status of the MJ/MN lamp on the PWR card.
• When the MN lamp lights, the office data has been normally registered.
• When the MJ lamp lights, the office data has not been normally registered.
Repeat STEP 1-STEP 2.
STEP3: On the MP card, set the SW3 to “0”.
• The MP card has been changed to the ON LINE mode.
HOW TO LOAD RESIDENT SYSTEM PROGRAM
To Next Page
Loading...
