NEC UNIVERGE NEAX 2000 IPS - [Cm35] Trunk Route Data

– 342 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
FUNCTION:
This command is used to assign trunk route characteristics. A trunk route is a group of trunks with com-
mon characteristics used for a common purpose.
PRECAUTION:
(1) The table below shows the value of the Central Office trunk or Tie line trunk (COT/DID/ODT/
LDT/DTI/BRT/PRT/CCT) PAD assigned by CM35 Y=19, Data 4-7.
(T: Transmitter PAD [dB], R: Receiver PAD [dB])
[Australia/New Zealand]
T/R: Transmit/Receive
+: Gain
–: Loss
Continued on next page
CONNECTION PATTERNS
(A-B)
PAD DATA OF B TRUNK
DATA=4 (T/R) DATA=5 (T/R) DATA=6 (T/R) DATA=7 (T/R)
Station-ODT 0/0 0/0 0/0
Tone-ODT 0/0 0/0 0/0
COT/DID/LDT/IPT-ODT 0/0 –8/–8 –8/–8
ODT-ODT 0/0 –8/–8 –3/–3
DTI/BRT/PRT/CCT/Virtual IPT-ODT 0/0 –8/–8 –3/–3
Station-COT/DID/LDT 0/+6 0/+6 0/+6
Tone-COT/DID/LDT 0/+6 0/+6 0/+6
COT/DID/LDT/IPT-COT/DID/LDT 0/+6 –6/+6 –6/+6
ODT-COT/DID/LDT 0/+6 –6/+6 0/+6
DTI/BRT/PRT/CCT/Virtual IPT-COT/DID/
LDT
0/+6 –6/+6 0/+6
Station-DTI/BRT/PRT/CCT 0/0
Tone-DTI/BRT/PRT/CCT 0/0
COT/DID/LDT/IPT-DTI/BRT/PRT/CCT 0/0
ODT-DTI/BRT/PRT/CCT 0/0
DTI/BRT/PRT/CCT/Virtual IPT-DTI/BRT/
PRT/CCT
0/0
CM35