– 440 – NWA-008844-001 Rev.5.0
91ch3004.fm
COMMAND CODE
TITLE:
PURPOSE OF PBR/CFT/SDT
45
FUNCTION:
This command is used to define the purpose of PB (DTMF) Receiver (PN-8RST) and Conference trunk
(CFT). This command is also used to make the CFT, PBR and the Caller ID Sender (SDT) busy.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
+ 45Y + +
PBR/CFT/SDT
++ +
NUMBER
DATA
(2-3 digits)
EXE
ST
DEDE
(1 digit)
: Initial Data
NOTE: Set the PBR card number as follows.
00-15: PBR for a system that is not provided Remote PIM over IP feature or a Main site of
Remote PIM over IP feature. (00 is dedicated to built-in PBR of MP card.)
16-45:Built-in PBR for a Remote site (No. 01-30) of Remote PIM over IP feature.
Continued on next page
Y PBR/CFT/SDT NUMBER SETTING DATA
RELATED
COMMAND
No. MEANING No. MEANING DATA MEANING
0 Make busy con-
dition of PBR
XX Z XX: PBR card number
Built-in PBR of MP
card: 00
PN-8RST: 01-45
NOTE
Z : Circuit number
(0-3)
0
1
Make busy
In service
CM10/CM14>E2XX
1 PBR for incom-
ing call from Tie
line/DID
0
1
Only for incoming
call from Tie line/
DID
For both DTMF
station and Tie line/
DID
CM10/CM14>E2XX
CM35 Y=01
2 PBR for Auto-
mated Attendant
only
0
1
Only for Auto-
mated Attendant
For both DTMF
station and Tie
Line/DID/Auto-
mated Attendant
CM30
CM41
Y=0>33, 43
CM10/CM14>E2XX
CM45
To Next Page
Loading...
