NEC UNIVERGE NEAX 2000 IPS - Page 463

– 439 – NWA-008844-001 Rev.5.0
91ch3004.fm
COMMAND CODE
TITLE:
EXTERNAL EQUIPMENT STARTING CONDITIONS
44
The following table shows the interface condition of each external equipment.
EQUIPMENT KIND INTERFACE RELATED COMMAND REMARKS
External tone source ODT Interface • CM10/CM14: DA00
• CM48 Y=0
• Use ODT card
• Ground Start by “M” line of ODT
•RA
• RB line of ODT for tone
COT Interface + External
Equipment Interface
• CM10/CM14
: DA00
: E800-E831
• CM44>0
• CM48 Y=0
• Use COT, DK of MP card/DK00
card
• Loop Start by DK of MP card/
DK00
•Tip
• Ring of COT for tone
Wake Up Call/Timed
Reminder tone source
ODT Interface • CM10/CM14: DB00
• CM48 Y=1
• Use ODT card
• Ground Start by “M” line of ODT
•RA
• RB line of ODT for tone
COT Interface + External
Equipment Interface
• CM10/CM14: DB00
• CM44>01
• CM48 Y=1
• Use COT, DK of MP card/DK00
card
• Loop Start by DK of MP card/
DK00
Speaker Paging COT Interface + External
Equipment Interface
• CM10/CM14
: D000-D255
: E800-E831
• CM20: A070-A079
• CM30 Y=28
•CM35
• CM44>02
• Use COT, DK of MP card/DK00
card
• Loop Start by DK of MP card/
DK00
Radio Paging COT Interface
(Loop Start)
• CM10/CM14
: D000-D255
• CM20: A070-A073
• CM30 Y=28
•CM35
•Use COT card
• Loop Start by Tip
• Ring of COT
Relay control via D
term
External Equipment Inter-
face
• CM10/CM14
: E800-E831
• CM44>15
•CM90
• Use DK of MP card/DK00 card
CM44