NEC UNIVERGE NEAX 2000 IPS - [Cm08] Basic Service Features

– 88 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
FUNCTION:
This command is used to assign basic features on a system wide basis.
PRECAUTION:
After setting 1st data 335, 368, 390, 391, 392, 396, 420, 477, 478, 487, system reset is required.
ASSIGNMENT PROCEDURE:
DATA TABLE:
BASIC SERVICE FEATURE: 010-096
+08+ +
BASIC SERVICE
++ +
FEATURE
DATA (0/1)
(3 digits)
EXE
ST
DEDE
(1 digit)
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
010 Operator Overlapping
[Australia Only]
0
1
Not available
Available
011 Operator Monitoring
[Australia Only]
0
1
Not available
Available
012 Attendant Override/Busy Verification 0
1
Not available
Available
014 Attendant Loop Release 0
1
Available
Not available
018 Attendant Night Transfer 0
1
Not available
Available
See CM51 Y=13
020 Terminating to Attendant Console by receiving Forward GII
signal on DID MFC call
[Not used in North America]
0
1
Not allowed
To allow
021 Station-to-Station call during a C.O. outgoing connection or
outgoing call transfer
0
1
Restricted
Allowed
025 MSG Display on D
term
0
1
MSG (only)
MSG X (X: No. of message)
026 Group Diversion 0
1
Available
See CM16 Y=2 CM19 Y=6
Not available
Continued on next page
JULY/01/2006
CM08