– 89 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
027 A hold tone is sent to overlap call
[Australia Only]
0
1
To send
Not sent
028 C.O. to C.O. transfer by station or attendant
NOTE: This data is effective for C.O. trunks (Ground Start/
Loop Start) which receive a release signal from the
C.O.
0
1
To allow
Not allowed
029 When tandem call duration passes a predetermined time, the
call is disconnected or continued
(Related Command: CM35 Y=119, CM41 Y=0>54)
0
1
To disconnect
To continue
032 When a dial-in incoming call from a tie line or DID line is
addressed to vacant levels or unassigned stations, the call is
routed to a predetermined station, Attendant Console or Digital
Announcement Trunk
0
1
Restricted (ROT connection)
Predetermined station, ATTCON or
Digital Announcement Trunk
assigned by CM51 Y=06, 07
034 Receiving Tone when the destination goes on-hook while a line
is connecting to a destination.
[For EU]
[Series 3200 R6.2 (R6.2)]
NOTE: In Germany, you have to set setting data to 0.
0
1
BT
ROT
035 Toll Restriction for an outgoing call by Speed Calling-Station
(Station Speed Dialing)
0
1
Not provided
Provided
036 Buzzer indication when a call remains held at Attendant
Console over a preprogrammed period of time assigned by
CM41 Y=0>00 Buzzer indication for Automatic Recall
0
1
Not available
Available
037 Select the detection method of incoming Ground Start trunks
Ring signal
NOTE: This is useful when AC induction is present on Ground
Start trunks.
0
1
Detect only, Ring cycle only
Detect Ring cycle and Ground Lead
Continued on next page
NOVEMBER/15/2006
CM08
To Next Page
Loading...
