– 157 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
LAN DATA ASSIGNMENT
0B
FUNCTION:
This command is used to provide the LAN interface of the system, TCP/UDP port for use of the D
term
IP
and Virtual IP trunk (Virtual IPT), VLAN function, and Simple Network Management Protocol (SNMP).
PRECAUTION:
When providing Remote PIM over IP, set up the following Data for Main Site and Data for Remote Site.
Only Data for Main Site is set up when not using Remote PIM over IP.
ASSIGNMENT PROCEDURE:
DATA TABLE:
Y=00-03
INITIAL
Data for Main Site Data for Remote Site
LAN data setting for the system CM0B Y=00>00-02, 05, 40, 41, 98 CM0B Y=31-60>00-02, 05, 40, 41
VLAN data setting CM0B Y=02>00-04 CM0B Y=31-60>30-34
Survival Mode – CM0B Y=31-60>50, 51, 52, 53
SNMP data setting CM0B YY=03>00-02, 10, 11, 20-27, 30-
33, 40-43, 50-53, 60-63, 70-77, 80-83, 90
CM0B Y=101-115>00-02, 10, 11, 20-27,
30-33, 40-43, 50-53, 60-63, 70-77, 80-
83, 90
Remote Site number – CM0B Y=00>90
+ 0BYY + + + + +
2ND DATA
EXE
ST
DEDE
(1-32 digits)
1ST DATA
(2 digits)
: Initial Data
NOTE: To provide the VLAN function to the system, clear the IP Address and Subnet Mask for the
system that has been set by CM0B Y=00>00 and 01 after setting the data by CM0B
Y=02>03 and 04.
Continued on next page
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
00 LAN data setting for the
system
00 IP Address for
the system
NOTE
000000000000
255255255255
NONE
IP Address
No data
~
JULY/01/2006
CM0B
To Next Page
Loading...
