NEC UNIVERGE NEAX 2000 IPS - Page 180

– 156 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
LAN INTERFACE ASSIGNMENT
0A
IPT INITIAL
IP-PAD INITIAL
SIP INITIAL
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
112 TCP/UDP/RTP Port of
LAN Interface 28 for SIP/
IP-PAD
[Series 3200 R6.2
(R6.2)]
90
92
93
94
UDP Port for
Voice control
TCP Base Port
for H.245 con-
trol
RTP Base Port
for Voice Packet
transmitting/
receiving
UDP Port for
SIP control
packet
[Series 3600]
01024
65534
NONE
TCP/UDP/RTP Port number
1st data=90: 50000
(Port number 50000
is used)
1st data=92: 6000
(Port number 6000-
7024 are used)
1st data=93: 10000
(Port number 9998-
10317 are used)
1st data=94: 05060
(Port number 05060
is used)
NOTE 1: 10 ports from the TCP/
UDP/RTP Port num-
ber are used per LAN
Interface.
NOTE 2: The same port number
cannot be used for the
port number which
UDP Port for Voice
control (1st data=90),
TCP Port for H.245
control (1st data=92)
and RTP Port for
Voice Packet transmit-
ting/receiving (1st
data=93).
113 TCP/UDP/RTP Port of
LAN Interface 29 for SIP/
IP-PAD
[Series 3200 R6.2
(R6.2)]
114 TCP/UDP/RTP Port of
LAN Interface 30 for SIP/
IP-PAD
[Series 3200 R6.2
(R6.2)]
115 TCP/UDP/RTP Port of
LAN Interface 31 for SIP/
IP-PAD
[Series 3200 R6.2
(R6.2)]
~
DECEMBER/02/2005
CM0A