– 206 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
VIRTUAL LINE NUMBER
11
FUNCTION:
This command is used to assign station numbers, Intercom numbers, Loop Line numbers and ICI/OPR
Line numbers (for D
term
Attendant Position) to Virtual Lines assigned on D
term
.
PRECAUTION:
(1) Virtual Line station numbers must be different from station numbers assigned by CM10/CM14.
(2) The virtual LEN has no relation to the LEN used in CM10/CM14.
Therefore, any virtual LEN can be assigned to each Virtual Line station number.
(3) The following station data can be assigned to the Virtual Line station numbers.
• Station Class-1 (CM12)
• Station Class-2 (CM13)
• Service Restriction Class (CM15)
• Call Pickup Group/Group Diversion Group (CM16)
• ACD/UCD Group (CM17)
• Station Hunting Group (CM18)
• Direct-in Termination in Day/Night Mode (CM30 Y=04, 05)
• Call Forwarding-Busy Line
• Call Forwarding-Don’t Answer (-No Answer)
• Call Forwarding-I’m here (-Destination)
• Call Pickup
• Call Back (In this setting, My Line number is called back.)
• Outgoing Trunk Queuing (Trunk Queuing-Outgoing) (In this setting, My Line number is called
back.)
(4) The virtual LEN which can be assigned depends on software version is as follows.
000-255 [Series 3300 software or before]
0000-1019 [Series 3400 software or later]
Continued on next page
CM11
To Next Page
Loading...
