INTRODUCTION
– 1 – NWA-008844-001 Rev.5.0
91ch0001.fm
INTRODUCTION
PURPOSE
This manual explains all of the commands required for programming the NEAX 2000 IPS, using the Cus-
tomer Administration Terminal (CAT) or Maintenance Administration Terminal (MAT).
OUTLINE OF THIS MANUAL
This manual consists of four chapters. The following paragraphs summarize Chapters 1 through 4.
CHAPTER 1 HOW TO USE CAT
This chapter explains how to use the Customer Administration Terminal (CAT)
which is used as the man-machine interface with the PBX.
CHAPTER 2 PRECAUTION
This chapter explains precautions for using commands, such as condition for using
commands, method of setting on-line/off-line mode, port allocation, password
entry, and nation code assignment.
CHAPTER 3 COMMAND DESCRIPTION
This chapter explains the function, precaution, assignment procedure and data table
of each command.
CHAPTER 4 RESIDENT SYSTEM PROGRAM
This chapter explains how to load the Resident System Program and the service
conditions, and contains the data table.
APPENDIX A LEN ASSIGNMENT
This appendix contains the location of Line Equipment Number (LEN) for each
system configuration and the data assignment.
APPENDIX B TERMINAL KEY ASSIGNMENT
This appendix contains the key number layout of each D
term
, ATTCON,
DESKCON, DSS Console, and Add-On Module.
JULY/01/2006
PURPOSE/OUTLINE OF THIS MANUAL
To Next Page
Loading...
