NEC UNIVERGE NEAX 2000 IPS - [Cm20] Numbering Plan;Single Digit Feature Access Code (Programmable)

– 288 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
NUMBERING PLAN/SINGLE DIGIT FEATURE ACCESS CODE
(PROGRAMMABLE)
20
FUNCTION:
Trunk routes and features are assigned by developing access codes. For Route Advance and Tenant
development, see CM22 and CM23.
The following figure shows the relationship between commands:
PRECAUTION:
(1) If “7XX” (XX=20-83) is displayed when reading out the assigned data for the access code, the
access code which was entered is the leading digits of another access code consisting of more
digits. Add a digit to the entered access code and try again (to determine the other access code).
Then decide which one to use or delete/change (not enough digits entered).
(2) If “WRONG” is displayed when reading out the assigned data for the access code, another access
code already exists with the same leading digits. Delete the last digit and try again (to determine
the other access code). Then decide which one to use or delete/change (too many digits entered).
Continued on next page
Numbering Plan Group
For each
tenant
(4 groups)
CM29
CM20
CM23
CM25
CM22
For each access code
Station No.
Access Code for Service Feature
Trunk Route
(24 blocks)
Tenant Block
For each Tenant
Access Code for Service Feature
Trunk Route
(16 blocks)
Special Terminal Block
Trunk Route
For each ordinary Station
Numbering Plan Route Advance Block
Trunk
Route
Route
Advance
Block
(32
blocks)
JANUARY/20/2006
CM20