– 785 – NWA-008844-001 Rev.5.0
91ch3009.fm
COMMAND CODE
TITLE:
SMDR/CIS/PMS FUNCTIONS (1)
D000
FUNCTION:
This command is used to assign the Station Message Detail Recording (SMDR), Call Information Sys-
tem (CIS), and Property Management System (PMS) functions.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
1ST DATA: 2-88
ST
EXE++ +
+
D000
2ND DATA
DE
1ST DATA
(1-3 digits) (0/1)
++
DE
: Initial Data
1ST DATA
2ND DATA
DATA FUNCTION
2 Language of the messages to be printed out 0 : Japanese
1 : English
3 Monetary unit of the bill to be displayed 0 : YEN (XXX, XXX)
1 : $ (¢) (XXXX. XX)
5 By operation for Call Record printout shown below, only the
totaled bill is printed out without printing the individual data.
Operation for Audit Printout:
Operation for Interim Printout:
0 : Not available
1 : Available
7 In printout of totaled bill for individual station, the station num-
bers of the station of which amount of bill is $0.00 is printed.
0: YES
1: NO
8 In printout of call record for individual station, the station num-
ber of the stations of which amount of bill is $0.00 are printed.
0: YES
1: NO
Continued on next page
RESET++ +
900
CR
PRT DET + GRT +
++ +
900
CR
PRT DET + GRT + SET
JULY/01/2006
CMD000
To Next Page
Loading...
