NEC UNIVERGE NEAX 2000 IPS - [Cm05] Ap;Fp Card Type, Highway Channel

– 60 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
AP/FP CARD TYPE, HIGHWAY CHANNEL
05
FUNCTION:
This command is used to designate the type of application processor (AP)/firmware processor (FP) card
installed.
PRECAUTION:
(1) This command requires a system reset after data setting.
(2) The available value of first data of CM05 (FP/AP number) depends on the software version used
in the system.
Assign the correct FP/AP number to each FP/AP, referring to tables below.
[For Series 3200 R6.1 software or before]
×: Available –: Not available
[For Series 3200 R6.2 software]
×: Available –: Not available
INITIAL
FP/AP No.
FP/AP TYPE
00 01-03 04-15 16-19 20-31 32-59 60-63
FP card (PN-CP15) – × – × –––
MP built-in FP × ––––––
DAIA/DAID card – × – × –––
Virtual FP for D
term
IP – × – × –––
AP card – – × – × ––
Virtual AP (Virtual IPT) – – × – × ––
Continued on next page
FP/AP No.
FP/AP TYPE
00 01-03 04-15 16-19 20-31 32-59 60-63
FP card (PN-CP15) – × – × –––
MP built-in FP × ––––––
Virtual FP for D
term
IP – ××××––
AP card – – × – × ––
Virtual AP (Virtual IPT) – – × – × ––
CM05