– 268 – NWA-008844-001 Rev.5.0
91ch3002.fm
COMMAND CODE
TITLE:
CALL PICKUP GROUP/GROUP DIVERSION GROUP
16
DATA TABLE:
: Initial Data
Y STATION NUMBER (A) SETTING DATA
No. MEANING DATA MEANING DATA MEANING
0 Station numbers to
be included in Call
Pickup Group
X
XXXXXXXX
Station number (A) X
XXXXXXXX
NONE
Station number (B)
No data
When assigning station numbers to a Call Pickup group, only two station numbers can be
assigned per operation. Thus, by repeating the operation as often as required, all the station
numbers to be included in a Call Pickup group can be assigned. The two station numbers to
be assigned by one operation are defined as Station number (A) and Station number (B).
For example, when defining a Call Pickup group with station numbers 300, 301, and 302,
three operations are performed.
Station number (A)
Station number (B)
1st Operation 300 301
2nd Operation 301 302
3rd Operation 302 300
By these three operations, a chain of three lines is set up. As seen from above, one station
can be either Station Number (A) or Station Number (B). Thus, Station Number (A)/(B) is
used for identifying which of the two station numbers is to be set first.
2 Station number
included in Group
Diversion
X
XXXXXXXX
Station numbers to be
included in a Group Diver-
sion
00
30
NONE
Group Diversion Group 00
Group Diversion Group 30
See CM19 Y=6
No data
3 Display of station
numbers included in
Call Pickup group
By entering a station number as the first data, the station numbers included in the group are
displayed by pressing the key.
OPERATION
DISPLAY
1st STN A+ STN A: STN B
2nd + STN B: STN C
3rd + STN C: END
Continued on next page
~
~
~
~
~
DE
DE
DE
DE
CM16
To Next Page
Loading...
