NEC UNIVERGE NEAX 2000 IPS - Page 522

– 498 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
AUTOMATED ATTENDANT
64
: Initial Data
Y
TENANT
SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
3 Number of Queue Limit
for TAS, Day Mode
00-63 01
99
NONE
1 line
99 lines
No limit
CM51 Y=26, 30
CM76 Y=16
4 Number of Queue Limit
for TAS, Night Mode
CM51 Y=27, 30
CM76 Y=16
5 Number of Queue Limit
for TAS, Mode A
CM51 Y=28, 30
CM76 Y=16
6 Number of Queue Limit
for TAS, Mode B
CM51 Y=29, 30
CM76 Y=16
10 Trunk access code for
call forwarding in
Mobility Access mode
[Series 3700 R12.1]
X-XXXX
NONE
Trunk Access Code
(1-4 digits)
No data
CM15 Y=216
CM76 Y=41
11 Trunk access code for
ISDN Alternative Rout-
ing in Remote PIM sur-
vival mode
[Series 3700 R12.2]
X-XXXX
NONE
Trunk Access Code
(1-4 digits)
ISDN Alternative Rout-
ing disabled
12 Method of ISDN Alterna-
tive Routing in Remote
PIM survival mode
[Series 3700 R12.2]
0
1
2
3
Destination station num-
ber of each station
Destination station num-
ber of each tenant
Destination station num-
ber of each tenant + Sub-
address
ISDN Alternative Rout-
ing disabled
CME6 Y=51
NOTE: When the 2nd data is set to “0” and CME6 Y=51 is set to “NONE”, this command operates as well
as 2nd data is set to 1.
13 Destination of ISDN
Alternative Routing in
Remote PIM survival
mode (tenant basis)
[Series 3700 R12.2]
00-63 X
XX...XX
NONE
Destination C.O. line
number (Maximum 26
digits)
No data
CM64 Y=12
NOTE: When 2nd data of CM64 Y=12 is set to “1/2”, the destination is set by this command.
~ ~
~
JULY/01/2006
CM64