– 118 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
432 Forced release when called ISDN Terminal does not answer
during 3 minutes
0
1
Not available
Available
434 ISDN CPN (Calling Party Number) when making a call from
ISDN Terminal
0
1
CPN entered in ISDN Terminal
CPN assigned by CM12 Y=12/13
441 Recall display on Attendant Console 0
1
Available
Not available
442 UCD Busy Out from Sub line 0
1
Available
Not available
443 Type of Voice Mail System (VMS) 0
1
As per CM12 Y=25
VMS with DTMF signaling
444 Message Waiting lamp control from VMS with MCI to all
stations
NOTE: MW lamp control is only available to stations in the op-
posite PBX connected with CCIS via MCI. Station dial-
ing MW access codes are not allowed over CCIS.
0
1
Available
Not available
445 Pressing Paging key on ATTCON/DESKCON when the atten-
dant is in idle
0
1
Available
Not available
448 When D
term
station dials “*#” during setting of One-Touch keys 0
1
“*#” is set as dialed digit
“*#” is set as a delimiter mark
between dialed number and DTMF
signal
449 DID call to station with Call Forwarding-Don’t Answer-CCIS
set to a busy destination station.
Destination has no call forwarding set.
0
1
Ring continuously at forwarded DID
station
Drop to busy signal after time set by
CM41 Y=0>01
450 Fault Information Storing 0
1
Not stored
To store
451 Fault Information Memory overflow 0
1
No fault information is registered in
case of Fault Memory overflow
Fault information is overwritten in
case of Fault Memory overflow
456 Whether the system clock is set when the system clock setting
command is received from the RMAT
0
1
Not set
To set
Continued on next page
JULY/01/2006
CM08
To Next Page
Loading...
