– 123 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
531 DTG (Digital Tone Generator) for IP-CS
[For PHS]
[Series 3300]
0
1
NEAX 2000 IPS Specification
NEAX 2400 IPX Specification
534 System operation after the C.O./Tie line (via TRK-B) is com-
pleted when a station that has a C.O./Tie line call (via TRK-A)
on consultation hold is talking with another C.O./Tie line call
(via TRK-B)
[Series 3300]
0
1
Return to the original call
(via TRK-A)
ROT
537 Duration of displaying the name when the incoming call is
answered/the select key for Calling Number Display and Call-
ing Name Display or CID key is pressed
[Series 3300]
0
1
Until call is finished/key is pressed
again
6 seconds
NOTE: This command is effective from Series 3300 software up to Series 3600 software. When using Series
3700 R12.2 software or later, set this data by CM08>580.
538 Duration of displaying the destination information when the
outgoing call is answered by the destination via CCIS/ISDN
[Series 3300]
0
1
Until call is finished
6 seconds
542 Type of Camp-On from ATTCON
[Series 3400]
0
1
Semi-Automatic Camp-On
Automatic Camp-On
543 Whether the step call is to be restricted or not
[Series 3500]
0
1
Restricted
Allow
548 Selection of the Guest information displayed on an administra-
tive station (D
term
/Attendant Console) for 8 characters display
in left-side on upper line of LCD
[Series 3400]
0
1
Display PMS information A/B
Display VIP/language
549 Whether the PMS information for 8 characters display in left-
side on upper line of LCD is to be displayed on Attendant Con-
sole or not
[Series 3400]
0
1
Display information assigned by
CM08>548
Not displayed
553 Inquiry Dial Tone sent to a station makes SHF on Consultation
Hold
[For EU]
[Series 3500]
0
1
DT
SPDT
Continued on next page
NOVEMBER/15/2006
CM08
To Next Page
Loading...
