NEC UNIVERGE NEAX 2000 IPS - Page 152

– 128 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
624 Alternative Routing when the MB switch of IPT/IP-PAD card is
ON/LAN cable of IPT/IP-PAD card is pulled out in tandem
office or when all outgoing trunks of tandem office are make
busy condition
[Series 3600]
0
1
To provide (CGC sending)
Not provided (CFL sending)
626 In ETSI ISDN Overlap Receiving, whether the system connects
to the calling party when the system does not receive the fol-
lowing DID number within the time set by CM41 Y=0>109,
after the first DID number of the calling party is received
[For EU]
[Series 3200 R6.2 (R6.2)]
0
1
Not connected
To connect
627 In ETSI ISDN Overlap Receiving, whether the system connects
to the calling party when the DID number of digits received
from ISDN is more than the maximum number of digits
assigned by CM85 Y=0-7
[For EU]
[Series 3200 R6.2 (R6.2)]
0
1
Not connected
To connect
628 Link Reconnect-Peer-to-peer CCIS
[Series 3300]
0
1
To provide
Not provided
NOTE: This command is effective when CM08>606 is set to 1.
629 Connected line number indication on ATTCON/DESKCON
display in ETSI ISDN Connected Line Identification Presenta-
tion (COLP)
[For EU]
[Series 3300]
0
1
Not provided
To provide
633 Trunk access code display when a call terminates via ETSI
ISDN
[For EU]
[Series 3300]
0
1
Available
Not available
644 ETSI ISDN Overlap Sending
[For EU]
[Series 3300]
0
1
To provide
Not provided
Continued on next page
BRT INITIAL
DTI INITIAL
NOVEMBER/15/2006
CM08