– 130 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
677 Output message which is sent from PBX to ISDN network
when the 2nd line is released by Mobility Access hooking
[Series 3700 R12.2]
NOTE: This data is effective only when the 2nd data of
CM08>676 is set to 0.
0
1
CALL PROC + ALERT + DISC
CALL PROC + ALERT +
CONNECT + DISC
679 Registering fault information (fault kind 43) by RTP monitoring
via SIP card
[Series 3700 R12.2]
0
1
Not provided
To provide
NOTE 1: This command is effective when the fault information (fault kind 43) is assigned by CMEA Y=2.
NOTE 2: When the second data of CM08>679 is set to 1, the registering fault information (fault kind 43) by
RTP monitoring via SIP card is performed as follows.
• When releasing the path by RTP monitoring via SIP card is provided (CM08>672: 0), the fault
information (fault kind 43) is registered whenever the path is released by RTP monitoring.
• When releasing the path by RTP monitoring via SIP card is not provided (CM08>672: 1), the fault
information (fault kind 43) is registered only one time.
699 “DND” display on D
term
/ATTCON when the D
term
/ATTCON
calls a station set the DND over CCIS
[Series 3600]
0
1
To provide
Not provided
Continued on next page
JULY/01/2006
CM08
To Next Page
Loading...
