– 132 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICE FEATURES
08
: Initial Data
BASIC SERVICE FEATURE SETTING DATA
713 Station number sent to VMS when accessing VMS from a sub-
line assigned on D
term
0
1
Subline station number
My Line station number
715 Soft Keys for Call Screening feature 0
1
Available
Not available
722 Sending of expanded information on Low Layer Compatibility
(LLC) information element for connection between ISDN ter-
minal/ISDN trunks
[Series 3200 R6.2 (R6.2)]
0
1
Allow
Restricted
723 Check of the LAN cable of IP-PAD card is pulled out in Alter-
native Routing by a fault occurrence
[Series 3600]
0
1
To check
Not checked
728 Sending Service Set Tone to participants when a new partici-
pant attends the conference
[Series 3500]
0
1
Not sent
To send
734 Method of specifying the starting AMP relay circuit
[Other than EU]
[Series 3900]
0
1
To specify by Access Code
To specify per trunk
NOTE 1: Set the second data to 0 when one Paging trunk is connected with multiple AMP relay circuits or with
two AMP relay circuits simultaneously.
NOTE 2: Set the second data to 1 when one Paging trunk is connected with one AMP relay circuit.
735 Method of connection the starting AMP relay circuit
[Other than EU]
[Series 3900]
0
1
To connect with two AMP relay
circuits
To connect with one AMP relay
circuit
NOTE 1: This command is effective only when the second data of CM08>734 is set to 0.
NOTE 2: Set the second data to 0 when one Paging trunk is connected with two AMP relay circuits simulta-
neously.
NOTE 3: Set the second data to 1 when one Paging trunk is connected with multiple AMP relay circuits or with
one AMP relay circuit.
Continued on next page
JUNE/01/2007
CM08
To Next Page
Loading...
